High Performance Protective Coatings For Industry,
Formulated With Patented Polymer Technology

ChemLine 784/32

Description
ChemLine® Caulk is a two (2) component 100% solid material manufactured with the same polymer as ChemLine®. ChemLine® Caulk is supplied in complete small sized kits for quick and easy repairs of caulk, joints, and coving.

Purpose
ChemLine® Caulk is a flexible, chemical resistant material for concrete flooring and secondary containment applications. This product is used to fill cracks and joints, and serves as a material for coving uses.

Packaging
ChemLine® Caulk is packaged in 1-quart or 1-gallon units.

Application Highlights

  • No volatiles released during cure
  • 100% solids
  • Can be applied at temperatures from 41°F to 104°F (5°C to 40°C)
  • Resists thermal shock
  • Temperature resistance from -40°F to 302°F (-40°C to 150°C)
  • Outstanding chemical resistance
  • Easy to apply

General Application Information

Repair instructions provided on the reverse side. Visit www.adv-polymer.com for additional information.

 

Application Data

Pre Surface Preparation

A) Pre-surface preparation includes a detergent wash and chemical cleaning of all surfaces to be repaired.

B) All surfaces must then be dried.

Application Method

Apply ChemLine® Caulk using a putty knife, trowel or similar.

Clean-up

Use MEK, MIBK, Toluene, Acetone.

Thickness

ChemLine® Caulk can be applied at horizontal thicknesses up to one (1) inch (2.5 cm). Additional lifts can be applied after
the material has reached a “B” stage. In vertical applications work with material in short lengths and allow to set up before
applying the next section up.

“B” Stage
The “B” stage has been reached when the caulk is firm-to-thetouch, i.e., the caulk has lost its tackiness, and one cannot easily
indent the caulk with a finger nail. This typically requires 4-6 hours at 75°F (24°C).

Recoat Time
The ChemLine® Caulk can be overcoated with ChemLine® 784/32 or ChemLine® 2400/32 after the caulk has reached the “B” stage.

Curing
Full chemical resistance is reached in 5-7 days. Contact APC for specific resistance based upon actual conditions of service.

OBSERVE ALL SAFETY REQUIREMENTS DURING THIS PROCEDURE, INCLUDING WEARING ALL PROPER SAFETY EQUIPMENT.

 

 

The furnishing of the information contained herein does not constitute a representation by Advanced Polymer Coatings, Ltd. (APC) that any product or process is free from patent infringement claims of any third party, nor does it constitute the grant of a license under any patent of APC or any third party. APC assumes no liability for any infringement which may arise out of the use of the product. APC warrants that its products meet the specifications which it set for them. APC DISCLAIMS ALL OTHER WARRANTIES and relating to the products and DISCLAIMS ALL WARRANTIES RELATING TO THEIR APPLICATION expressed or implied INCLUDING but not limited to warranties of MERCHANT ABILITY AND FITNESS for particular purpose.

Receipt of products from APC constitutes acceptance of the terms of the Warranty; contrary provisions of purchase orders not withstanding. In the event that APC finds that products delivered are off-specification, APC will at its sole discretion, either replace the products or refund the purchase price thereof. APC’s choice of one of these remedies shall be Buyer’s sole remedy. APC will under no circumstances be libeled upon for consequential damages except in so far as liability is mandated by law. APC will deliver products at agreed upon times in so far as it is reasonably able to do so, but APC shall not be liable for failure to deliver beyond its reasonable control.

Product covered under one or more of the following patents or patents pending. 5,169,912 5,658,996 5,874,501

© Copyright 2010