High Performance Protective Coatings For Industry,
Formulated With Patented Polymer Technology

ChemLine 784/32

Description
ChemLine® Putty is a two (2) component 100% solid material manufactured with the same polymer as ChemLine®. ChemLine® Putty is supplied in complete small sized kits for quick and easy repairs to pitted steel and spalled concrete surfaces.

Purpose
ChemLine® Putty is a chemically resistant material for concrete flooring and pitted steel applications. This product is used to fill cracks in concrete and corroded or pitted areas in steel substrates.

Packaging
ChemLine® Putty is packaged in 1-quart or 1-gallon units.

Application Highlights

  • No volatiles released during cure
  • 100% solids
  • Can be applied at temperatures from 41°F to 104°F (5°C to 40°C)
  • Resists thermal shock
  • Temperature resistance from -40°F to 302°F (-40°C to 150°C)
  • Outstanding chemical resistance
  • Easy to apply

General Application Information

Repair instructions provided on the reverse side. Visit www.adv-polymer.com for additional information.

 

Application Data

Pre Surface Preparation

A) Pre-surface preparation includes a detergent wash andchemical cleaning of all surfaces to be repaired.

B) All surfaces must then be dried.


Application Method

Apply ChemLine® Putty using a putty knife, trowel or similar.


Clean-up

Use Methyl Ethyl Ketone, Toluene or Methyl Isobutyl Ketone.


Thickness

Concrete: ChemLine® Putty can be applied at thicknesses up to 40 mils DFT. Additional lifts can be applied after the
material has reached a “B” stage.
Steel: Average 1/4” - for pitted areas which are deeper than 1/4” contact factory for recommendation. (Consult APC
technical service for specifics on application instructions)

Recoat Time

ChemLine® Putty can be overcoated with any ChemLine® Coating Materials at any time after application. Do not walk on
ChemLine® Putty while wet.

Curing:
Full chemical resistance is reached in 7-9 days at 70°F (21°C) at ambient temperatures.


OBSERVE ALL SAFETY REQUIREMENTS DURING THIS PROCEDURE, INCLUDING WEARING ALL PROPER SAFETY EQUIPMENT.

Properties

VOC
100% Solids
Service Temperature
-40°F (-40°C) to 212°F (100°C)
Elongation
8-11%.
Bond Strength to Concrete
+500 psi (3.4 MPa)i

 

 

The furnishing of the information contained herein does not constitute a representation by Advanced Polymer Coatings, Ltd. (APC) that any product or process is free from patent infringement claims of any third party, nor does it constitute the grant of a license under any patent of APC or any third party. APC assumes no liability for any infringement which may arise out of the use of the product. APC warrants that its products meet the specifications which it set for them. APC DISCLAIMS ALL OTHER WARRANTIES and relating to the products and DISCLAIMS ALL WARRANTIES RELATING TO THEIR APPLICATION expressed or implied INCLUDING but not limited to warranties of MERCHANT ABILITY AND FITNESS for particular purpose.

Receipt of products from APC constitutes acceptance of the terms of the Warranty; contrary provisions of purchase orders not withstanding. In the event that APC finds that products delivered are off-specification, APC will at its sole discretion, either replace the products or refund the purchase price thereof. APC’s choice of one of these remedies shall be Buyer’s sole remedy. APC will under no circumstances be libeled upon for consequential damages except in so far as liability is mandated by law. APC will deliver products at agreed upon times in so far as it is reasonably able to do so, but APC shall not be liable for failure to deliver beyond its reasonable control.

Product covered under one or more of the following patents or patents pending. 5,169,912 5,658,996 5,874,501

© Copyright 2010